How to put the network on the river ?
Leisure / / August 12, 2017
- cargo, anchor
- rubber suit and boots
- boat, paddle
- License, which stipulates: size of the network and its cells, rate of fish catch
Choosing a pond for fishing, it is desirable to know its depth, shape and composition of the seabed.Just need to decide with the desired catch.It depends on this choice of length, width, height, and even the network itself, as well as the size of its mesh.Consider the need and the speed of the river - it affects the preparation and selection of cargo for the network setting.In rivers with strong currents may need a little anchor to hold in place a network statement.
Set network on the river should be together, it is easier to work and ensure safety on the water.You can put the network from the boat and one, but it is dangerous and difficult, especially in windy conditions.Browse some of the methods and types of activities will help you understand how to put the network on the river, that it was an easy and enjoyable exp
on small rivers or floods, where the shores are overgrown with reeds, willows network put in hand (vzabrod).A fisherman in a suit, and in warm weather, swimming across or along rivers and the coast.On narrow rivers, where it is possible to throw the cord on the other side, the network put in peretyag, pulling on both sides of the shores.Initially thrown cord, and then it is exposed on a floating network cord.In this case, the lower cord should be enough load to the network is not raised over.
on deep rivers network set from a boat.In this case one person scoops the oars in the direction of delivery, and the second straightening, lowers net into the water, starting from the place where the anchor is set to hold a network in place.In the deeper areas to better catch you need to select the installation grid horizon, and know how to put the network on the river, for this it is secured by several anchors at a given level and cargo cord is enough to pull down than to lift the floating cord.
winter network statement rather time-consuming affair.From cut through the main lane in a line at a distance of 2-3 meters smaller cuts through the lane.Then, via holes of the pole in the hole cord is passed, and so a sufficient length.Then, using this cord dipping well into the main chain, it is stretched to its full length.At the same time, on the load cable must be dressed enough cargo to make the vertical position of the network.