How to pull the starter sleeve ?
Repair And Maintenance / / August 12, 2017
- Bolt great length
- old bush
- Tap the desired size
- chuck from drill
If the starter began seriously to rotate, and the battery maintains its charge, then the problem is not so deep, it can be removed quickly and easily on their own.As a rule, it is sufficient to replace the starter motor bearings, but it is necessary to remove the sleeve.
first step is to check whether the hub gets his hands.If the starter several times to assemble and disassemble, surely he would have broken the nest and squeeze the sleeve can be a simple click on it.It should be noted that in this case it is recommended to replace the entire starter assembly as installation of a new sleeve will not give the desired effect, and such problems will soon occur again.
If described in the preceding paragraph does not happen, look at how to get the starter sleeve, close fitting to the landing nest.The first thing you need to disconnect the battery and the starter itself.To do this, remove
starter must be placed at the bottom of the bolt that holds it.It needs to be carefully unscrewed.However, we must be very careful.In some car models, this is the bolt secures not only a starter but also the engine.It is necessary to lift the motor on the jack, and place it under the backup.Now you can unscrew the bolt, remove the starter and get to work.
Now we need to take from the drill chuck and tighten it tap the desired diameter.It is necessary to take into account, when asked how to remove the plug starter, the metal of which it is sleeve - strong, so in case of the slightest misalignment or excessive force may break off the tap.Therefore, all must be done very carefully, slowly.
Cut into thread in the sleeve, it is necessary to take a large dine on bolt diameter and appropriate step, screw it and try to get a sleeve with suspenders pliers or something similar.There is usually no problem.If the tap is broken off, it is necessary to try to pull the chip and continue to cut the thread.If the starter repair has never been tested, the sleeve must themselves climb out after a few revolutions.If nothing helps to get them - will have to be drilled.