How should you top up the distilled water in the battery ?
Repair And Maintenance / / August 12, 2017
- sponge with soda solution
- large medical syringe
Many fans who purchased the car recently, may simply not know how to refill distilled waterbattery and you need to do.This equally applies to other household devices and appliances, the principle of which is built on the use of energy generated by the battery pack.There are several recommendations of experts, which allow to learn how to add water to the battery.The first step is to thoroughly clean the outer surface of the battery from the battery plaque and all impurities that were formed in the process.Such cleaning can get rid of unsafe flight sulfuric acid.This substance is dangerous for the person performing the work and for the correct operation of the device.
If the acid penetrates into the accumulator battery, then over time it necessarily lead to a malfunction.Cleaning is not a difficult or time consuming process, and for this you need only to clean contaminated surfaces with a sponge.As detergent the be
determine the required level of help specifically designed for this label on the battery case.If you look at the filler opening, then it is possible to consider the tides, which mark the lower and upper levels.Sometimes it happens that some models do not have these marks, or they are erased.In this case, refill needed to fifteen centimeters at most, and it serves as a guide when the top plate.In order to add a liquid spill as carefully as possible and as little as possible, it is better to use a special medical syringe large, rubber or plastic bulb or outer bulb aerometry (to properly measure the density of electrolytic material).Measurements must be carried out by one and the same time and it is better if they will be few.
liquid must be poured only in those containers in which the level of electrolytic material has dropped below the minimum.It is worth to know that after the water filling the inherent density of the electrolyte can not immediately recover.The thing is that the battery pack has not only plates, but also small spaces between them, which is why the diffusion of substances takes place much more slowly than would be held with the solid structure of the battery.In some cases, the density of the electrolyte can be returned to its original state only after a week.In order for the battery is not deteriorated, and continued to work, after the topping-up he must stand at least two hours without work.Only in this case the density of electrolytic substance will become closer to the desired and it will be possible to measure.
Determine readiness accumulator batteries for use just enough - we need only correlate obtained after topping-up results with topics that have been recorded previously.If the difference between them is not too large, then it means that the battery is ready for use.As the liquid in the battery Battery comes in consumption when recharging, the best moment to pour into it bude distilled water immediately after the device is fully charged.Special attention should be paid to the level of electrolytic substance.If its level reached the lowest level at which the battery plates are exposed to the adverse effects of the environment, this means that the battery just need to add a little liquid.
On how intensively the process of exploitation there is, depends on the frequency of the addition of water.If it's too hot, the water needs to be topped up frequently.In order to choose the optimal mode of topping up, is to constantly monitor how quickly evaporates the liquid in the recently acquired battery.Thus, you can not only find the time during which consumes electrolytic substance, but also to calculate the time for which consumed all the water needed for the normal battery life.It must be remembered that in the recently acquired liquid level devices could be at its lowest level.So before you add water to the battery, it is imperative to fully charge.