How to make heated seats with their hands : expert advice
Miscellaneous For Cars / / August 12, 2017
- drill or screwdriver
are commercially available automotive heaters of two types: external and embedded.By setting both the first and second species, make heated seats with their own hands will not be difficult.Incidentally, with regard to external heaters, they represent a special fabric seat cover that is easy to fasten elastic bands.It feeds the heater through the cigarette lighter.There are models that have a temperature controller.This type of heater in the installation is the most simple, but not so on embedded.It should be noted that the recessed heaters are divided into two types.The first are those that are made in the form of a piece of cloth, which is recommended to hide under the cover of the regular seats.That's only in this case, there are disadvantages associated with the unreliability of the design: the fabric can slide, and if it peredavit, it will stop working or can burn seat.
But the second type of heater include
So, to set the self-adhesive plate it is necessary, first of all, to prepare the car for mounting.For this purpose it is necessary to carry out the dismantling of the front seats, so it will be much easier to get rid of the regular seat lining.As a rule, the nominal trim always fixed from the bottom by means of special hooks.Further recommended to go to a partial dismantling of the vehicle seat.Everything is done so that there is full access not only to the chair and the floor area, which is located between the front passenger and driver's seats.With regard to this the floor area of the seat to its torpedo dismantled, to be able to further implement the connection of heating elements to seat wiring machine.Only after this work can safely proceed to the removal of the front trim.
It is said that the removal of skin specialists believe filigree affair as each car make and model has its own individual design of car seats.Just for this reason, it is strongly recommended before beginning work well acquainted with all technical documentation and learn the basic rules of such removal.After this you can proceed to the process of removing the skin.Once it is removed, the surface that was free, you need to stick the plate according to the principle - the two bottom and two on the back seat.It is important that the plates were completely the same distance.But to place the plate near the edge of the seat is not recommended, as they will be of little effect.In this manner they are fixed on the two chairs.After gluing the plates put back covers and the seat is fixed in place.
wires that go from the heater, stretch across the bottom seat under the carpet car, in the center console or door.Now the main task - to determine the location of buttons with which you can turn on / off the heater.For these buttons you need to drill or screwdriver to make holes.The buttons are inserted and then fixed.By the way, post heating control buttons as desired can be both the torpedo and in absolutely any interior segment, as long as the driver was convenient to use them.At the time of connection is necessary to note that from the heater are two wires, one of which is connected to ground car, the other - on the plus ignition.In this connection seat heater would work by turning on the ignition, which is very convenient.
This is how you can manually increase the temperature in the cabin of your car and go on a long trip, even at very low temperatures.But in this case, too, there are nuances.For example, buying a car seat heaters, must be very well acquainted with their operating principle, the ins and outs, as well as to pay special attention to the material from which they are made.In addition, installation is strictly forbidden as heaters that are not intended for use in conditions of home use.Otherwise, it can cause ignition of the car!But the heated seat buttons will look great inside the car if they are equipped with LED, so even on the dark area display can be turned on without much effort.
12 Aug, 2017